Skip to main content

Arduino Nano ESP32

FeatureSpecs
ModuleNORA-W106(ESP32-S3)
Flash16MB
PSRAM❌
Screen**240x140
SubGHZSX1276
NavigationNavigation button
WiFi✅
BLE✅
USB OTG✅
NFCPN532
Battery chipTP4057

Here you can find breadboard boards of CapibaraZero on Arduino Nano ESP32(photo is outdated):

And here the electrical diagram:

CapibaraZero Arduino Nano ESP32 diagram

You can also download the original project here

Arduino Nano ESP32 pinout​

With an Arduino Nano ESP32 board you must use the following pin if you doesn't want to modify source code:

SD card​

For the SD card we must use the SPI bus.

  • CS: pin D10
  • MOSI: pin D11
  • MISO: pin D12
  • SCK: pin D13

SX1276​

For the SX1276 we must use the SPI bus. We use the same pin of SD card but make sure to change CS pin since is the one that identify the devices on SPI bus.

We also need DIO 1 and DIO 2 pin to receive data from module in OOK/FSK mode. LoRa™ mode use SPI to get data.

  • DIO1: pin D0
  • NSS: pin D7
  • DIO2: pin D1
  • MOSI: pin D11
  • MISO: pin D9
  • SCK: pin D13

PN532​

Make sure to put PN532 in I2C mode since we use it in this way. You can also use in UART mode or SPI mode but you need to change source code

  • SCL: pin A6
  • SDA: pin A7

Display​

  • SCL(SCLK): D4
  • RST: Not connected
  • SDA(MOSI): D2
  • CS: pin D6
  • DC: pin D5
  • BLK: 3v3

IR​

  • Emitter: D3
  • Receiver: D8

TP4057​

  • BAT+: A0

Buttons​

  • Right: pin A1
  • Down: pin A2
  • OK: pin A3
  • Left: pin A4
  • Up: pin A5